Logo
Builders' Plan Gallery  |  Hip Pocket Web Site  |  Contact Forum Admin  |  Contact Global Moderator
December 17, 2017, 04:25:54 PM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with email, password and session length
 
Home Help Search Login Register
Pages: [1]   Go Down
Print
Author Topic: Full flaring prop block  (Read 457 times)
0 Members and 1 Guest are viewing this topic.
mkirda
Gold Member
*****

Kudos: 12
Offline Offline

United States United States

Posts: 610

Topic starter
WWW

Ignore
« on: April 25, 2015, 10:27:59 PM »

I had a request from a customer and developed a new jig to make a full flaring prop block.
Instead of the spar line being dead center, it is just inside the block edge.

I have tested another jig and can now cut balsa blocks down to 12"P pretty easily.
The limit now is the length of the lever arm and at 12"P you run out of arm at about 8" block length.
Probably not a huge concern - Most flyers will never have use for a 16" Diameter prop with a 12" Pitch.

Regards.
Mike Kirda
Logged

Pages: [1]   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!