Hip Pocket Builders' Forum

Indoor Free Flight Forum => General Discussion => Topic started by: Osennikov on July 26, 2019, 07:32:17 AM



Title: 3D PRINT WINDER
Post by: Osennikov on July 26, 2019, 07:32:17 AM
hello, has anyone tried to make a winder on a 3d printer?


Title: Re: 3D PRINT WINDER
Post by: pedwards2932 on July 26, 2019, 07:51:28 AM
I saw this on Thingaverse but I haven't tried printing it yet:

https://www.thingiverse.com/thing:1043534


Title: Re: 3D PRINT WINDER
Post by: Osennikov on July 26, 2019, 06:11:16 PM
I saw this on Thingaverse but I haven't tried printing it yet:

https://www.thingiverse.com/thing:1043534
thanks a lot, i will definitely try next week ;)


Title: Re: 3D PRINT WINDER
Post by: fred on September 01, 2019, 12:27:03 PM
Looks good in the Illustration.
 Suspect the Capability of one's printer to print decent gear teeth is the crucial bit though As a temporary ; while fiddling with printing.
A fishing reel makes for a passable winder.
 Often surplus  to needs, so free as well.
 Even new these can be had for Very few $