Logo
Builders' Plan Gallery  |  Hip Pocket Web Site  |  Contact Forum Admin  |  Contact Global Moderator
September 22, 2019, 09:58:46 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with email, password and session length
 
Home Help Search Login Register
Pages: [1]   Go Down
Print
Author Topic: Problems keeping line ends under reel clips  (Read 590 times)
0 Members and 1 Guest are viewing this topic.
sleepy gomez
Bronze Member
***

Kudos: 1
Offline Offline

United States United States

Posts: 79

Topic starter


Ignore
« on: December 24, 2015, 02:40:29 PM »

I have had problems keeping the loose ends of control lines on the reel with the reel clip.
I have solved the problem for me.
Cut a 2 1/2" long piece of 3/8" wood dowel.
Lay the reel clip on its side.
No need to cut the dowel.
Drive one end of the dowel on the center part of the clip.
Apply a spot of epoxy to seal the end.
Install the line clip as usual then push the other end of the dowel into the reel.
It is also easier for old fingers to remove the clip.
Logged
David Murrell
Bronze Member
***

Kudos: 0
Offline Offline

Australia Australia

Posts: 15



Ignore
« Reply #1 on: December 26, 2015, 12:35:04 AM »

Cheep and cheerful Sleepy, raid 'er indoors sewing box for a length of 3/8" elastic, tie into a loop and slip over the clip and the reel.

Cheers
Logged
greggles47
Gold Member
*****

Kudos: 11
Offline Offline

Australia Australia

Posts: 283




Ignore
« Reply #2 on: December 28, 2015, 06:12:36 AM »

My solution is even cheaper and doesn't risk annoying the little lady.

Get a bit of 3/8" sq from the scrap box and use that as a wedge under the clip. If its too loose go to 3/8 X 1/2.
Logged

There must be some way out of here, said the joker to the thief,
There's too much confusion, I can't get no relief
Pages: [1]   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!