Builders' Plan Gallery  |  Hip Pocket Web Site  |  Contact Forum Admin  |  Contact Global Moderator
April 20, 2019, 06:13:09 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with email, password and session length
Home Help Search Login Register
Pages: [1]   Go Down
Author Topic: KP 01 motor  (Read 155 times)
0 Members and 1 Guest are viewing this topic.
Bronze Member

Kudos: 5
Offline Offline

New Zealand New Zealand

Posts: 70

Topic starter

« on: February 08, 2019, 10:40:20 PM »

I have one of the older KP 01 motors that came with a housing on the back which holds 4 50mAh Nicads.
It's been hanging around for about 10 years and I figure it's time I used it.
I would like to upgrade it to the later version which are set up for Lipos. Before I remove the batteries and housing is there any tips, tricks or technique I should be aware of?
I would like to use one of my Zombie controllers to control it and also, if it's not too hard, the double plug set up   that came with the motor whereby the charging lead goes into a charging jack which also acts as the power switch
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!